GHD Hip Extension

What Is the GHD Hip Extension?
GHD Hip Extension is an isolation exercise that primarily targets the glutes and hamstrings and also engages the erector spinae and adductor magnus. It is an intermediate-level movement performed face down on a glute-ham developer (GHD), with the hip pad under the front of the hips and the feet locked between the ankle rollers, so the body folds at the hips while the spine stays neutral.
Pad position is what makes this a hip extension. The hips sit just over the front edge of the pad, so the pelvis is free to tip forward and the work comes from the glutes and hamstrings. Slide forward until the hip crease rests on top of the pad and the hips can no longer fold, and the same machine turns the movement into a back extension, where the spine rounds and straightens instead. It also differs from the Glute-Ham Raise, which uses the same machine but bends the knees, and from the Hyperextension, which is done on a 45-degree bench.
Because the GHD holds the legs level with the floor, the torso travels from hanging straight down to horizontal. The weight of the upper body pulls hardest at the top, where the torso is parallel to the floor and the glutes are fully shortened, so the finish of each rep is the hardest part. On a 45-degree bench the hardest point comes partway down instead, which is one reason the GHD version feels tougher at lockout.
The GHD Hip Extension is a common accessory in CrossFit programming, where it is taught next to the back extension and the GHD Sit-Up to build posterior chain strength and control of a neutral spine. Lifters also use it after deadlifts, squats or sprint work to add hip extension volume without a bar on the back. It can be loaded by holding a weight plate or medicine ball against the chest.
It suits anyone who already has a basic hip hinge and enough back strength to hold a straight torso against gravity. If full-range reps are too hard, build up with the Hyperextension, the Bodyweight Good Morning or a shorter range on the GHD. The key skill is finishing each rep by squeezing the glutes rather than arching the lower back, so a deliberate focus on the glutes at the top pays off here.
Muscles Worked
- Biceps Femoris
- Primary
- Gluteus Maximus
- Primary
- Erector Spinae
- High
- Semimembranosus
- High
- Semitendinosus
- High
- Adductor Magnus
- Medium
Instructions
- Adjust the GHD so that, lying face down, the front of your hips sits just over the front edge of the hip pad and your feet fit between the ankle rollers with your knees straight.
- Climb on face down and lock your feet between the rollers, with the pad under the top of your thighs and your hips free to bend over its edge.
- Cross your arms over your chest and line your body up straight from heels to head, parallel to the floor.
- Brace your abs and keep your knees straight and your spine neutral.
- Hinge at the hips and lower your torso toward the floor under control.
- Go down until your torso hangs close to vertical, or stop sooner if your lower back starts to round.
- Squeeze your glutes and drive your hips into the pad to raise your torso, moving only at the hips.
- Stop when your body forms a straight line parallel to the floor, without arching past it.
- Keep your head in line with your spine and your eyes on the floor throughout, then repeat for the prescribed reps.
Common Mistakes
Setting the pad too high
With the hip crease resting on top of the pad the hips cannot fold, so the lower back rounds and does the work the glutes and hamstrings should.
Rounding the lower back at the bottom
Reaching for extra depth by curling the spine turns the rep into a back extension, so stop lowering as soon as the lower back starts to round.
Arching past straight at the top
Finishing above a straight line from heels to head shifts the load from the glutes into the lumbar spine.
Dropping fast and bouncing
Falling into the bottom and rebounding out of it uses momentum instead of the hip extensors and jolts the hamstrings and lower back.
Craning the neck up
Lifting the head to look forward at the top arches the upper spine, so keep the neck in line with the torso and the eyes on the floor.
Injuries
GHD Hip Extension is a low risk exercise when performed with proper technique. There is no bar on the back and the spine is not compressed, so most problems come from losing spinal position: rounding the lower back to reach the bottom, or arching past a straight line at the top, both of which shift the work from the hips into the lumbar spine.
The lower back is the main strain point, followed by the hamstrings, which are under stretch at the bottom and can cramp or strain if you drop fast and bounce out of the hole. A hip pad set too high or too low can also press painfully into the hips or thighs and block the hinge. Set the pad so the front of the hips sits just over its edge, lower under control, stop each rep when the body is straight and come up slowly after a set, since hanging head-down can leave you light-headed.
If full range is too demanding, shorten the range and add depth over time, or train the same hinge on the 45-degree Hyperextension. The Reverse Hyperextension works the same muscles with the torso supported. Once bodyweight reps are smooth, progress with a pause at the top or a plate held against the chest.
Stop if you feel sharp or pinching pain in the lower back, pain, numbness or tingling running down a leg, or a sudden pull or cramp in the back of the thigh. Anyone with a current back injury should get clearance from a physical therapist or doctor before loading this movement.
- Primary Focus
- Glutes and hamstrings
- Equipment
- Body weight
- Modality
- Strength
- Difficulty
- Intermediate
Alternative Exercises
Other Names for the GHD Hip Extension
The GHD Hip Extension is also known as:
- Glute-Ham Developer Hip Extension
Frequently Asked Questions
- Q: What is the difference between a GHD hip extension and a GHD back extension?
In the hip extension the pad sits under the front of the hips, the hips fold and the spine stays neutral the whole time. In the back extension the hip crease rests on the pad, so the hips are locked and the spine rounds and straightens instead. CrossFit also teaches a hip-and-back extension that combines the two in sequence.
- Q: How is it different from a hyperextension on a 45-degree bench?
The GHD keeps the legs level with the floor, so the torso travels from hanging straight down to horizontal and the top of the rep is the hardest point. On the 45-degree Hyperextension bench the hardest point comes partway down and the finish is easier, which makes it the gentler place to learn the movement.
- Q: Is the GHD hip extension the same as a glute-ham raise?
No. The Glute-Ham Raise sets the pad under the thighs and bends the knees to pull the body up, so the hamstrings work at the knee as well as the hip. The hip extension keeps the knees straight and moves only at the hips.
- Q: How do I make GHD hip extensions harder?
Hold a weight plate or medicine ball against your chest, pause for two to three seconds at the top, or slow down the lowering. Moving the load from the chest to behind the head or overhead lengthens the lever and makes it much harder, so add that only once chest-loaded reps stay clean.
- Q: What if I can't do a full-range rep yet?
Lower only as far as you can keep your lower back flat and still come back up to straight, then add depth over time. You can also build the hinge first on the 45-degree Hyperextension or with the Reverse Hyperextension.




