Sled Reverse Fly

What Is the Sled Reverse Fly?
Sled Reverse Fly is an isolation exercise that primarily targets the shoulders, especially the rear deltoids, and also engages the upper back muscles that draw the shoulder blades together. It is a beginner-level movement performed with a pair of handles on a strap attached to a weighted sled. You face the sled and sweep your arms from in front of you out to your sides, and each rep drags the sled a short way toward you.
The rear deltoids and the muscles between the shoulder blades are easy to undertrain next to all the pressing most programs include, and the reverse fly is one of the simplest ways to give them direct work. The sled version fits naturally into a sled session, as an upper-body finisher, or in a conditioning circuit alongside pushes and drags, and it needs no cable station or rack.
What sets it apart from other reverse fly versions is that the sled only resists while you pull. As your arms come back to the front, the strap goes slack, so there is no loaded lowering phase. That makes it easy to train for higher reps with little next-day soreness, but it also means it covers only the pulling half of the movement, so it works best alongside a fly with a loaded return such as the Dumbbell Reverse Fly or the Cable Reverse Fly.
The rear deltoids lead the movement, helped by the small rotator cuff muscles at the back of the shoulder and by the middle trapezius and rhomboids. Because the straps run down to the sled and your hands finish at shoulder height, the rest of the deltoid and the upper trapezius also work to lift the arms against that downward pull. Keeping the elbows fixed is what keeps it a fly; once the elbows bend and travel back, the work shifts to the lats and biceps and the movement becomes the Sled Row.
It suits beginners, team-sport athletes and anyone looking for low-impact upper back work. If holding the arm path with straight arms is hard, learn it first with the Band Pull Apart or the Band Reverse Fly, then move to the sled with a light load.
Muscles Worked
- Deltoid
- Primary
- Infraspinatus
- High
- Rhomboid Major
- High
- Upper Trapezius
- High
- Lower Trapezius
- Medium
- Teres Minor
- Medium
Instructions
- Load the sled with a light weight and attach a strap with two handles to the front of the sled.
- Face the sled, take a handle in each hand and walk backward until the straps are taut with your arms extended in front of you at about waist height.
- Stand with your feet about hip-width apart and your knees slightly bent. Keep your chest up and brace your midsection.
- Set a slight bend in your elbows and keep it fixed for the whole set.
- Sweep the handles out and up to your sides until your arms reach shoulder height in line with your body.
- Squeeze your shoulder blades together briefly at the top without shrugging.
- Bring the handles back in front of you. The sled will have slid a short way toward you.
- Take a step or two back to remove the slack from the straps, then repeat for the desired reps.
Common Mistakes
Loading the sled too heavily
A heavy sled forces you to lean back and shrug to move it, which takes the work off the rear deltoids.
Bending the elbows into a row
Letting the elbows bend and travel back turns the fly into a row and hands the work to the lats and biceps.
Shrugging the shoulders
Lifting the shoulders toward the ears lets the upper trapezius take over and loads the neck.
Leaning back to move the sled
Throwing the torso backward uses body weight instead of the shoulders and strains the lower back.
Starting with slack in the straps
Pulling on loose straps lets the sled snap the arms at the start of the rep instead of meeting smooth resistance.
Pulling the arms too far back
Driving the hands behind the line of the body adds stress to the front of the shoulder without working the rear deltoids any harder.
Injuries
Sled Reverse Fly is a low risk exercise when performed with proper technique. The load is light, the sled only resists while you pull, and your feet stay planted during each rep, so there is little to go wrong when the sled weight is sensible.
The usual strain points are the front of the shoulder, the upper trapezius and neck, and the elbows. Driving the arms well behind the line of your body stresses the front of the shoulder, shrugging under a sled that is too heavy loads the neck, and locking the elbows straight puts the strap's pull through the elbow joints. Starting a rep with slack in the straps lets the sled jerk the arms, and leaning back to drag an overloaded sled moves the strain into the lower back. Keep a soft, fixed bend in the elbows, stop when your arms are in line with your shoulders, take the slack out before every rep, and check the floor behind you before stepping back.
To make it easier, remove weight from the sled or use the Band Pull Apart or Band Reverse Fly. To progress, add weight in small steps, add reps, or pause briefly with the arms out to the sides. Stop if you feel a sharp or pinching pain in the shoulder, or numbness or tingling down the arm.
Frequently Asked Questions
- Q: How heavy should the sled be for a reverse fly?
Light. Pick a load that slides a short way on every rep while your elbows stay fixed and your shoulders stay down, which for many people is an empty sled or one small plate. If you have to lean back or shrug to move it, take weight off.
- Q: Do I stay in place or walk backward during the set?
Stand still for each rep, then take a step or two back to remove the slack before the next one. Some coaches have lifters walk backward slowly through the set to keep the straps taut, which works too as long as the arm path stays the same.
- Q: Why does the sled reverse fly feel easier on the way back?
The sled only resists while you pull, so the straps go slack as your arms return to the front and there is no loaded lowering phase. That keeps next-day soreness low and suits higher reps, but pair it with a fly that loads the return, such as the Dumbbell Reverse Fly, if the rear deltoids are a priority.
- Q: Where does the sled reverse fly fit in a workout?
It works well near the end of an upper-body or sled session, or as one station in a conditioning circuit. Because the load is light and there is no lowering phase, it can also follow heavy pressing without leaving the shoulders overly fatigued.
- Q: What can I do instead if I don't have a sled?
The Band Reverse Fly and Cable Reverse Fly follow the same standing arm path. The Machine Reverse Fly is a good option when you want a fixed path and easy loading.




