Barbell Hang Clean (Below the Knee)

What Is the Barbell Hang Clean (Below the Knee)?
Barbell Hang Clean (Below the Knee) is a compound exercise that primarily targets the back, glutes, quads and hamstrings and also engages the shoulders and core. It is an advanced-level movement: you lower the bar from standing to a hang just below the kneecaps, pull it explosively from there and receive it on the front of the shoulders in a full front squat.
The start position is what sets it apart from the standard Barbell Hang Clean, which begins above the knee. From below the knee the bar has to travel past the knees under your own control, so you must move the knees back out of its path, keep the shoulders over the bar and keep the bar close to the legs before the explosive second pull begins at the thigh. It is close to a full clean from the floor, but the bar never rests on the ground, so the back and hips hold tension through the whole start.
Weightlifters and their coaches use it as a technique and strength variation of the clean, half of the clean and jerk in Olympic weightlifting. It suits lifters who hit their knees with the bar, push the knees too far back, or start the second pull too early, because it isolates the moment the bar passes the knee. The longer pull also gives more time and distance to accelerate than a hang above the knee, so most lifters can handle heavier loads than in a high hang, with more of the work going to the glutes and hamstrings.
The catch is a full squat, so this is not the same lift as the Barbell Hang Power Clean, which receives the bar above parallel. Build the clean from above the knee first, along with a solid Barbell Front Squat and Barbell Romanian Deadlift. If holding a flat back while lowering into the hang is the problem, the Barbell Block Clean starts from a similar height without the lowering, and the Barbell Hang Snatch (Below the Knee) trains the same below-knee start for the snatch.
Muscles Worked
- Biceps Femoris
- Primary
- Erector Spinae
- Primary
- Gluteus Maximus
- Primary
- Upper Trapezius
- Primary
- Vastus Lateralis
- Primary
- Vastus Medialis
- Primary
- Adductor Magnus
- High
- Rectus Femoris
- High
- Deltoid
- Medium
- Rectus Abdominis
- Medium
Instructions
- Stand with your feet about hip-width apart and take an overhand grip on the barbell just outside your thighs, slightly wider than shoulder width.
- Deadlift the bar to standing, brace your trunk, then push your hips back to lower the bar down your thighs and past your kneecaps.
- Stop when the bar sits just below your knees, with your shins close to vertical, your shoulders slightly in front of the bar, your back flat and your arms straight.
- Keep your weight over the middle of your feet and push the floor away to move the bar up past your knees, keeping it close to your legs and your back angle unchanged.
- As the bar reaches your upper thighs, drive your hips and knees to full extension and shrug, letting the bar brush the top of your thighs.
- At full extension, pull yourself down under the bar with your elbows bending high and out, moving your feet slightly wider into your squat stance.
- Whip your elbows forward around the bar and receive it on the front of your shoulders with your fingertips under it, sinking straight into a full front squat.
- Settle in the bottom with your elbows high and chest up, then stand up out of the squat.
- Lower the bar back to your thighs under control and reset the below-knee hang for the next rep.
Common Mistakes
Shifting onto the toes in the hang
Letting the weight drift forward as you lower below the knee pulls the bar away from the shins and sends it on a looping path through the rest of the pull.
Leaving the knees in the bar's path
Not moving the knees back enough as you pull from the hang forces the bar to hit the knees or swing out around them.
Starting the second pull too early
Driving the hips forward while the bar is still at or below the knees pushes the bar away from the body and puts the shoulders behind it too soon.
Rounding the back while lowering
Losing the flat back as the bar travels down past the knees puts the lower back under load in a weak position before the lift even starts.
Bending the arms early
Pulling with the arms before the legs and hips finish extending cuts the drive short and slows the bar.
Catching with low elbows
Receiving the bar with the elbows pointing down lets it pull the chest forward in the squat and loads the wrists instead of the shoulders.
Injuries
Barbell Hang Clean (Below the Knee) is a medium risk exercise when performed with proper technique. Weightlifting as a sport is not especially injury prone: a 2024 systematic review of competitive weightlifters found 2.4 to 3.3 injuries per 1,000 hours of training, with the knee, lower back, shoulder and hands among the most common sites. In this variation the lower back works hardest, because you lower the bar past the knees and hold it there in a hinged position before pulling. The wrists and elbows take load in the front rack, and the knees take it in the bottom of the squat catch.
Lower into the hang slowly with the trunk braced and the back flat, and keep your weight over the middle of the foot rather than the toes. Use bumper plates, start light enough that the bar passes the knees without contact, and loosen the grip to the fingertips in the rack if your wrists are stiff. If you miss a rep, push the bar forward and step back rather than trying to hold it in a collapsed squat.
If your back rounds as the bar passes the knees, go back to the Barbell Hang Clean from above the knee or the Barbell Block Clean, and strengthen the position with the Barbell Clean Pull. Once the below-knee hang is consistent, progress to the Barbell Squat Clean from the floor. Stop the set if you feel sharp pain in the lower back, wrist or elbow pain in the rack that does not ease when you adjust your grip, or knee pain in the bottom of the squat.
Other Names for the Barbell Hang Clean (Below the Knee)
The Barbell Hang Clean (Below the Knee) is also known as:
- Low Hang Clean
Frequently Asked Questions
- Q: How is this different from a regular hang clean?
The Barbell Hang Clean starts above the knee, so the bar never has to pass the knees. Starting below the knee brings that transition back into the lift, which makes it longer, more technical and closer to a full clean from the floor.
- Q: Where exactly should the bar sit in the hang?
Just below the kneecaps, roughly at the bump at the top of the shin where the patellar tendon attaches. Keep the shins close to vertical, the shoulders slightly in front of the bar and the back at the same angle you would have with the bar at the knee.
- Q: Should I pause in the hang position?
Either works. A pause of a second or two makes you own the position and balance before you pull, while lowering straight into the pull lets you use the stretch in the hips and hamstrings and usually feels lighter.
- Q: Can I lift more from below the knee than from above it?
Usually, yes. The longer pull gives you more time and distance to accelerate the bar and brings the glutes and hamstrings into the lift, so most lifters handle more weight here than from a high hang.
- Q: Is the catch a full squat or a power position?
This version is received in a full front squat. If you catch the bar above parallel and stand up from there, you are doing a hang power clean, which is a separate lift.




