Arm-Over-Arm Truck Pull

What Is the Arm-Over-Arm Truck Pull?
Arm-Over-Arm Truck Pull is a compound exercise that primarily targets the back and also engages the biceps, forearms, rear shoulders, core and legs. It is an advanced-level movement in which the athlete sits on a low platform with the feet braced against a fixed block and reels a truck in on a rope, one grip after another, while staying in place as the vehicle rolls toward them.
It is a classic strongman event, usually listed as the arm-over-arm pull, and it sits alongside the standing harness Truck Pull as one of the sport's vehicle events. Competition rules generally require the athlete to stay seated with the feet against the block for the whole pull, and the event is run for time over a set distance.
Although it looks like an arm event, strongman coaches describe it as depending heavily on leg drive and grip. Each pull starts with the knees bent and the arms reaching forward, then the legs push against the block while the torso leans back, so the lats and arms finish a pull that the legs and hips started. Coaches compare that drive and lean to a partial deadlift done from a seated position. Grip endurance often decides the result, because the hands have to clamp a thick rope again and again with no rest, and keeping the truck rolling matters as much as the first heave, since a stalled vehicle is much harder to restart.
The movement suits strongman competitors preparing for the event and experienced lifters who want heavy horizontal pulling with a grip and conditioning element. Few gyms have a truck, so most athletes build the pattern with a rope Sled Pull, heavy rows such as the Cable Seated Row and dedicated grip work before pulling a vehicle. Anyone new to strongman should build a solid base of rows and deadlifts first.
Muscles Worked
- Latissimus Dorsi
- Primary
- Biceps Brachii
- High
- Brachialis
- High
- Deltoid
- Medium
- Erector Spinae
- Medium
- Rectus Abdominis
- Medium
- Rhomboid Major
- Medium
- Upper Trapezius
- Medium
Instructions
- Park the truck on flat ground in neutral with a driver or spotter ready to stop it, and run the rope straight from its tow point to the pulling platform.
- Sit on the platform facing the truck with your knees bent and the soles of your feet pressed firmly against the foot block.
- Lean slightly forward and reach out with straight arms to grip the rope with both hands close together, one in front of the other.
- Brace your core and set your shoulders down and back so your spine stays neutral.
- Drive your feet into the block to straighten your legs while you lean your torso back and pull the rope in toward your chest.
- Finish the pull lying back close to flat, with your legs extended and your hands at your chest.
- Keep the rope pinned with one hand, sit back up with your knees bent, and reach the free hand forward to grab the rope farther out.
- Bring the other hand over to join it and start the next pull straight away so the truck keeps rolling.
- Let the slack pile off to one side of your hip, away from your feet.
- Keep pulling until the truck crosses the finish line or reaches the set distance, then let the spotter bring it to a stop.
Common Mistakes
Pulling with the arms only
Curling the rope in with the arms while the legs stay passive overloads the biceps and slows the truck, because the leg drive and lean back should start every pull.
Rounding the lower back
Letting the spine collapse as you lie back or sit up shifts the load onto the lower back instead of the hips and legs.
Letting the truck stall
Pausing between grips lets the vehicle lose momentum, and getting it rolling again from a standstill takes far more force than keeping it moving.
Feet slipping off the block
Losing contact with the foot block costs leg drive and breaks the seated rule in competition, so set the feet firmly before the first pull.
Short, choppy reaches
Grabbing the rope close to the body wastes the leg drive, so reach fully forward with each new grip to cover more rope per pull.
Letting the rope tangle
Slack piling around the legs or feet can catch on the next pull, so feed it off to one side of the hip.
Injuries
Arm-Over-Arm Truck Pull is a medium risk exercise when performed with proper technique. The biceps and the other elbow flexors take a heavy, repeated load as each hand grabs a rope that is already under tension, and the lower back works hard during the lean back and the sit-up, especially if the spine rounds. In a survey of 213 strongman athletes, the lower back, shoulder and biceps were among the most commonly injured areas across strongman training as a whole.
Warm up the elbows, shoulders and back thoroughly, and let the legs and the lean start every pull instead of curling the rope in with the arms. Keep the spine neutral as you lie back and as you sit up again. Set the truck up on flat ground with a driver or a spotter with a wheel chock ready to stop it, make sure the course ends well before the vehicle can reach the platform, and keep your hands and feet clear of the rope pile.
Learn the pattern on a lighter rope Sled Pull before moving to a vehicle, and progress by adding either weight or distance, not both at once. If the full vehicle is too much, a lighter car or a shorter course keeps the technique intact.
Stop if you feel a sharp pain or a pop at the front of the elbow or in the upper arm, a sudden strain in the lower back, or pain running down a leg. A pop in the biceps area needs prompt medical assessment.
Frequently Asked Questions
- Q: What is the difference between an arm-over-arm pull and a regular truck pull?
In a regular Truck Pull the athlete wears a harness and drives the vehicle forward with the legs. In the arm-over-arm version the athlete stays seated with the feet against a block and reels the vehicle in on a rope, so the back, arms and grip do far more of the work.
- Q: Can I train for it without a truck?
Yes. Tie a long rope to a loaded sled, sit with your feet braced and reel it in one grip after another, then walk the rope back out and repeat, as in a rope Sled Pull. Standing arm-over-arm rows on a drag sled also build the hand timing the event needs.
- Q: How heavy are the trucks in competition?
It depends on the show and the weight class. At the 2025 SCL World Truck Pull Championships, athletes pulled a 15,000 kg vehicle 25 meters for time, and the fastest finished in under 28 seconds.
- Q: Why do strongmen call this a leg and grip event?
Each pull starts with the knees bent and finishes with the legs driving against the block while the torso leans back, so the legs and hips supply much of the force that moves the vehicle. The hands then have to hold a thick, loaded rope for the whole course, and athletes who rely on their arms alone tend to tire and slow down.
- Q: How far should I lean back on each pull?
Leaning back lengthens each pull and lets your legs and body weight help, which is why many athletes finish a pull lying close to flat. The further you lie back, the further you have to sit up before the next reach, so use the depth that keeps the rope moving fastest without rounding your back.




