Barbell Deadlift with Chains

Barbell Deadlift with Chains

What Are Barbell Deadlift with Chains?

Barbell Deadlift with Chains is a compound exercise that primarily targets the glutes, hamstrings and lower back and also engages the quadriceps, adductors, upper back and grip. It is an advanced-level movement that hangs lengths of heavy chain from the ends of a conventional deadlift bar, so the load grows as the bar rises and more links leave the floor.

The point of the chains is accommodating resistance. In a straight-weight deadlift the bar feels heaviest off the floor and easiest near lockout, because leverage improves as the hips come through. Chains reverse that pattern: the bar is lightest where the lifter is weakest and heaviest where they are strongest, so there is no coasting through the top half of the pull. Powerlifters use the lift to build lockout strength, either as a heavy single or as fast, submaximal speed pulls. When 23 resistance-trained athletes pulled 30 to 70% of their max as fast as they could, adding chains let them keep producing force to the end of the pull and raised peak force, while bar speed and power dropped, and the heavier the chains and bar, the bigger both effects.

The glutes and hamstrings drive hip extension throughout, and the lower and upper back hold the torso rigid as the load peaks at lockout. The quads work hardest breaking the bar from the floor, which is the lightest part of the rep here, so this version shifts the challenge toward finishing the pull rather than starting it. Lifters who stall off the floor are better served by a Barbell Deficit Deadlift, while a Barbell Rack Pull is the other common tool for the top half. The same chain setup is used on the Barbell Squat with Chains and the Barbell Bench Press with Chains.

This variation suits experienced lifters with a consistent conventional deadlift, especially powerlifters and strength athletes whose lockout lags behind their start. Chains change the feel of every rep and make the top of the lift unforgiving, so most lifters get more from straight-weight pulling until their technique holds up under heavy loads. Build that base with the Barbell Deadlift and the Barbell Romanian Deadlift first.

Muscles Worked

MuscleActivation

Instructions

  1. Load the bar and loop one chain over each sleeve, outside the plates and clear of where they land, with equal chain on both sides and part of each chain resting on the floor.
  2. Stand with your feet about hip-width apart and the bar over your midfoot.
  3. Hinge at the hips and bend your knees to grip the bar overhand, hands just outside your legs.
  4. Bring your shins to the bar, brace your core, pull your shoulders down to tighten your lats, and keep your back flat.
  5. Push the floor away and drag the bar up close to your shins and thighs as the chains lift off the floor.
  6. Keep driving through the top as the load increases, bringing your hips forward until your hips and knees lock out together.
  7. Stand tall with your shoulders over the bar and your glutes squeezed, without leaning back.
  8. Lower the bar by pushing your hips back first, then bending your knees once it passes them, keeping it close to your legs.
  9. Set the plates down, let the chains settle, and reset your brace before the next rep.

Common Mistakes

  • Too much chain for the bar weight

    A light bar with heavy chains makes the top of the pull far heavier than the start, so the lifter breaks the floor easily and then gets dragged out of position at lockout.

  • Uneven chains

    Different amounts of chain on each side tilt the bar and twist the hips as the links leave the floor.

  • Plates landing on the chains

    Chains hung too close to the plates pile up underneath them, so the bar rocks or lands unevenly when it comes back down.

  • Leaning back to finish

    Fighting the heaviest part of the rep by arching the lower back and leaning behind the bar loads the spine instead of finishing with the glutes.

  • Letting the bar drift forward

    Losing lat tension lets the bar swing away from the legs as the chains rise, which puts the extra load far out in front of the hips.

  • Pulling before the chains settle

    Starting the next rep while the links are still swinging or bunched up gives an uneven load and a rushed setup.

Injuries

Barbell Deadlift with Chains is a medium risk exercise when performed with proper technique. The lower back takes the most stress, particularly at lockout, where the chains make the bar heaviest and lifters tend to lean back or let the spine extend to finish the rep. The hamstrings can be strained if the hips shoot up early, and the shins and knees can be scraped by a bar that drifts or by swinging links.

Most chain-specific problems come from the setup. Hang equal chain on both sides so the bar stays level as the links lift off the floor, keep the chains on the sleeves beyond the plates so the plates never land on them, and never let them hang in front of the bar, where they pull it away from the legs. Start with a modest chain load on your first sessions and add chain only once every rep locks out with the hips and knees finishing together.

If lockout is the problem but chains feel unstable, a Barbell Rack Pull trains the same range with a fixed load, and the Barbell Deadlift remains the base lift to return to. Progress by adding chain in small steps rather than by stripping weight off the bar to make room for more chain. Stop the set if you feel sharp pain in the lower back, pain or numbness running down a leg, or a pull in the back of the thigh, and stop when your grip or back position starts to fail before the hips lock out.

Frequently Asked Questions

Q: Why use chains instead of just adding more plates?

Plates weigh the same from floor to lockout, so the load you can handle is capped by the hardest point, which is usually off the floor. Chains keep the bottom manageable while making the top heavier, so you train lockout strength and have to keep pushing hard all the way to the top.

Q: How much chain should I use?

Most lifters start with one or two chains per side and adjust from there, keeping most of the load on the bar. Chain weight varies with link size, so weigh your chains or check their rating, and attach them the same way every session so your numbers stay comparable.

Q: Do chains make the deadlift work the glutes harder?

No, not in the one study that measured it. When 13 trained men deadlifted 85% of their max with about a fifth of the load in chains, matched to straight weight at the top, gluteus maximus activity and ground reaction forces were lower than without chains. Chains change where the hardest part of the rep sits rather than making the glutes do more work.

Q: Should I use chains or bands for deadlifts?

Both make lockout heavier, but bands have to be anchored to the platform and also pull the bar down faster on the way down, which makes them more fatiguing. Chains only add weight as they leave the floor, so they are easier to set up and usually gentler to recover from.

Q: Should beginners deadlift with chains?

Rarely. Chains are a tool for fixing a specific weak point in an already solid deadlift, and a newer lifter will gain more from adding weight to a regular Barbell Deadlift week to week.

Turn any exercise into a full workout.

Free for up to 5 clients, with 30 days of Pro to start. No credit card required.