Cable Deadlift

What Is the Cable Deadlift?
Cable Deadlift is a compound exercise that primarily targets the quadriceps and glutes and also engages the inner thighs, hamstrings, lower back and upper back. It is a beginner-level movement in which you stand between two low pulleys, hold a single handle in each hand at your sides, and stand up from a squat-depth start until your hips and knees are fully straight.
Because the handles sit beside your feet instead of a bar in front of your shins, you can start with your hips lower and your torso more upright than in a Barbell Deadlift. That spreads the work between the knees and hips, much like the Trap Bar Deadlift or the Dumbbell Deadlift, and keeps the lower back's share modest. The cables add a twist of their own. At the bottom they run almost flat along the floor to the pulleys, so they pull your hands outward more than they resist you standing up, and the lift feels lightest off the floor and heaviest as you near the top, the reverse of a barbell.
This is a different movement from the Cable Romanian Deadlift and the Cable Pull Through. Both of those are hip hinges with only a slight knee bend, so the hamstrings and glutes do most of the work. In the Cable Deadlift the knees bend deeply and every rep starts from the bottom, so the quadriceps carry a much larger share.
The weight stacks make the load quick to change and easy to start light, which suits beginners learning to lift from the floor with a flat back, lifters returning from a break, and anyone training legs in a gym without a lifting platform. It also works as a higher-rep leg accessory after squats or deadlifts. If reaching the handles with a flat back is a struggle, set the pulleys a notch higher or build the pattern with the Kettlebell Deadlift first. Once the stacks no longer challenge you, the Trap Bar Deadlift and Dumbbell Deadlift let you load the same position more heavily.
Muscles Worked
- Gluteus Maximus
- Primary
- Vastus Lateralis
- Primary
- Vastus Medialis
- Primary
- Adductor Magnus
- High
- Erector Spinae
- High
- Rectus Femoris
- High
- Biceps Femoris
- Medium
- Upper Trapezius
- Medium
- Soleus
- Low
Instructions
- Set both pulleys of a dual cable station to their lowest position, attach a single handle to each, and select the same weight on both stacks.
- Stand exactly halfway between the pulleys and in line with them, feet about hip to shoulder width apart and toes turned slightly out.
- Push your hips back and bend your knees until your thighs are about parallel to the floor, then grab a handle in each hand beside your feet with your palms facing in.
- Set your start position: arms straight, back flat, chest up and your weight spread across your whole foot.
- Brace your core and take the slack out of both cables before you rise.
- Drive through the floor and straighten your knees and hips together, keeping the handles close to your sides as the cables pull outward.
- Finish standing tall with your arms straight at your sides, the handles beside your thighs and your glutes squeezed, without leaning back or shrugging.
- Lower under control by pushing your hips back and bending your knees, keeping your back flat, until the handles return beside your feet.
- Stop just before the weight stacks touch down, then start the next rep.
- After the last rep, return the handles toward the pulleys under control instead of letting go.
Common Mistakes
Rounding the back to reach the handles
Reaching down to the low handles with a rounded spine moves the load from your legs onto your lower back, so squat only as low as you can with a flat back or raise the pulleys a notch.
Hips rising first
Letting your hips shoot up before your chest straightens your legs and turns the lift into a back-dominant pull, so drive your hips and shoulders up together.
Letting the cables pull your arms out
At the bottom the cables pull your hands outward, and letting your arms drift away from your body strains your shoulders and takes tension off your legs, so keep the handles close to your sides.
Knees caving inward
When your knees drift in on the way up, your glutes lose leverage and your knees take extra stress, so keep them pushed out in line with your toes.
Standing off-center
Standing closer to one pulley than the other makes one cable pull harder and at a different angle, so set your feet exactly halfway between the pulleys.
Dropping the weight
Letting the handles pull you down and the stacks crash between reps wastes the lowering phase and jars your back and shoulders, so lower under control and stop just before the plates touch.
Injuries
Cable Deadlift is a low risk exercise when performed with proper technique. The handles sit at your sides, the weight stacks cap how heavy you can go, and there is no bar to keep close to your shins, so the stress on your lower back stays modest compared with barbell deadlifts. The deep start still asks a lot of your hips, knees and spine, so the risk rises when you go heavy with poor position.
The usual trouble spots are the lower back, which strains when it rounds to reach handles that sit lower than your hips and ankles comfortably allow, and the knees, which take extra stress when they cave inward on the way up. At the bottom the cables pull your hands outward and slightly back, so letting your arms drift away from your body can strain the shoulders and elbows. Letting go of the handles or rushing the lowering phase can also yank your arms and slam the stacks.
Warm up your hips and legs first, brace before every rep, and squat only as deep as you can with a flat back. If the bottom position is too much, raise the pulleys a notch to shorten the range, or learn the pattern with the Kettlebell Deadlift. When the stacks get too light, progress to the Dumbbell Deadlift or the Trap Bar Deadlift.
Stop the set if you feel a sharp pain in your lower back, pain or tingling that travels down a leg, or pain inside the knee, and get it checked before loading the movement again.
Frequently Asked Questions
- Q: How is this different from the Cable Romanian Deadlift and Cable Pull Through?
The Cable Romanian Deadlift and Cable Pull Through are hip hinges with soft knees that load mainly the hamstrings and glutes. The Cable Deadlift starts from a deep knee bend with a handle at each side, so your quadriceps do far more of the work.
- Q: Why does the weight feel lighter at the bottom?
With the handles beside your feet, the cables run almost flat to the pulleys, so most of their pull is sideways rather than downward. As you stand up the cables become more vertical and resist you more, so the top of the lift is the hardest part, unlike a barbell deadlift.
- Q: Can I do it on a single low pulley or a wide cable crossover?
This version needs two independent low pulleys, one for each hand. A single pulley with a bar puts the load in front of your body, which is a different lift. On a wide cable crossover the cables pull your hands far out to the sides, so a narrower dual-pulley station works much better.
- Q: Can the Cable Deadlift replace a barbell deadlift?
Not for building maximal strength. The weight stacks limit how much you can load, so it works best as a learning tool, a lighter leg day option or a higher-rep accessory, while the Trap Bar Deadlift or Barbell Deadlift remain the heavy lifts.
- Q: How many sets and reps should I do?
Because the load is moderate, 3 to 4 sets of 8 to 15 reps suits most people. Stop each set while your back is still flat and your hips and chest still rise together.




