Smith Machine Frankenstein Squat

What Is the Smith Machine Frankenstein Squat?
Smith Machine Frankenstein Squat is a compound exercise that primarily targets the quads and also engages the glutes, adductors, shoulders and core. It is an intermediate-level movement in which the Smith machine bar rests on the front of the shoulders with no hands on it, while both arms reach straight forward at shoulder height to form a shelf for the bar.
With a free barbell, the Frankenstein squat is mainly a posture drill: the bar stays in place only while the torso stays upright and the arms stay level, and any forward lean sends it rolling. The Smith machine takes that feedback away. The rails hold the bar on a fixed vertical path, so it cannot roll off, and a forward lean shows up instead as the bar pressing toward the throat. That makes this version less of a teaching drill and more of a hands-free, quad-focused squat, where the load is limited by how much the shoulders can comfortably carry and how long the arms can stay up rather than by balancing the bar.
The bar sits in front of the neck and the torso stays upright, so the knees travel forward and the quadriceps do most of the work. Foot position shifts that balance. Feet set directly under the bar keep the emphasis on the quads, while feet walked out in front of it let you sit back against the bar and move more of the load to the hips and lower back. Squatting deeper brings in more glutes and adductors, and the front of the shoulders and the upper back work through the whole set to keep the arms level.
It suits lifters who want a front-loaded quad squat but cannot hold a front rack comfortably because of stiff wrists or elbows, since the hands only touch the bar to unhook and rehook it. It also works as a light warm-up before heavier squats. Because the rails do the stabilizing, it does not build the bar control of the Barbell Frankenstein Squat or the Barbell Front Squat, so use the free-bar version when the goal is front squat or clean technique. If it is too hard, build up with the Bodyweight Squat and the Dumbbell Goblet Squat first, and move to the Smith Machine Front Squat when you want to hold the bar and load it more heavily.
Muscles Worked
- Vastus Lateralis
- Primary
- Vastus Medialis
- Primary
- Gluteus Maximus
- High
- Rectus Femoris
- High
- Adductor Magnus
- Medium
- Deltoid
- Medium
- Soleus
- Minimal
Instructions
- Set the bar hooks just below shoulder height and the safety stops just below the lowest point of your squat.
- Step under the bar and rest it on the front of your shoulders, close to your throat but not pressing on it or on your collarbones.
- Hold the bar with both hands and set your feet about shoulder-width apart, directly under the bar, with your toes turned slightly out.
- Straighten your legs to take the weight, rotate the bar to unhook it, then let go.
- Raise both arms straight out in front of you at shoulder height, palms facing down, and push your shoulders slightly forward so the bar sits in the shelf they form.
- Brace your core, take a breath, and keep your chest tall and your eyes forward.
- Bend your hips and knees together and sit straight down, letting your knees travel forward in line with your toes.
- Lower until your thighs are about parallel to the floor, keeping your heels down, your torso upright and your arms level.
- Drive through your whole foot to stand back up, keeping your chest up and your arms at shoulder height.
- After your last rep, take hold of the bar again and rotate it back onto the hooks.
Common Mistakes
Dropping the arms
Letting the arms sink below shoulder height flattens the shelf on the front of the shoulders, so the bar settles onto the collarbones and throat.
Leaning forward into the bar
The rails keep the bar from tipping off, so a forward lean drives the throat into the bar instead and shifts work from the quads to the lower back.
Feet too far forward
Walking the feet well out in front of the bar lets you sit back against it, shifting the work from the quads to the hips and lower back.
Heels lifting off the floor
Rising onto the toes as the knees travel forward usually means the feet are set too far back under the fixed bar or the ankles need more mobility.
Skipping the safety stops
With no hands on the bar and no way to drop it forward, a rep you cannot finish can pin you unless the stops sit just below your lowest position.
Knees caving in
Letting the knees collapse inward instead of tracking over the toes puts extra stress on the knees, especially on the way up.
Injuries
Smith Machine Frankenstein Squat is a low risk exercise when performed with proper technique. The rails keep the bar from rolling off the shoulders, which is the main hazard of the free-bar version, and safety stops set just below your lowest position catch a rep you cannot finish. Most problems come from where the bar sits on the body and from a foot position that does not suit the fixed bar path.
Because the bar cannot move with you, a forward lean or sagging arms press it into the throat and collarbones instead of letting it roll away, which is uncomfortable and can make breathing hard. Feet set too far back push the knees forward and lift the heels, while feet set well in front of the bar let you lean back into it and load the lower back. Keep the bar on the shelf of the front shoulders with the arms at shoulder height, find your foot position with light sets, and add weight only while the bar still sits comfortably on the shoulders. Holding the arms out also tires the front of the shoulders, so end the set once the arms start to sink.
If the bar position is uncomfortable, regress to the Dumbbell Goblet Squat or the Machine Leg Press, or shorten the range to a depth you control. Progress to the Smith Machine Front Squat to hold the bar and use heavier loads, or to the Barbell Frankenstein Squat when you want the bar to test your posture.
Stop the set for sharp pain in the knees, hips or lower back, pinching at the front of the shoulders, or pressure on the throat that makes breathing difficult. You cannot let the bar fall forward off your shoulders as you can with a free bar, because the rails hold it, so lower under control until it rests on the safety stops, then step out from under it.
- Primary Focus
- Quads
- Equipment
- Smith machine
- Modality
- Strength
- Difficulty
- Intermediate
Alternative Exercises
Frequently Asked Questions
- Q: How is it different from the barbell Frankenstein squat?
The rails hold the bar on a fixed path, so it cannot roll off your shoulders when you lean forward or your arms drop. That makes it a steadier hands-free squat for quad work, but it loses the instant feedback that makes the Barbell Frankenstein Squat a front squat posture drill.
- Q: How do I unrack the bar without using my hands?
You use your hands only to unhook and rehook it. Hold the bar, stand up to take the weight, rotate it off the hooks, then let go and raise your arms, and at the end of the set take hold again and rotate it back onto the hooks.
- Q: Where should my feet be on a Smith machine Frankenstein squat?
Start with them about shoulder-width apart directly under the bar, and move them slightly forward only if your heels lift. A biomechanical model of the Smith machine squat showed that moving the feet forward in front of the knees or leaning the trunk forward shifts load toward the hips and lower back while reducing knee torque, so feet under the bar keep the work on the quads.
- Q: Is it a good option if front squats bother my wrists?
Yes, as long as your shoulders are comfortable with the arms held at shoulder height. The wrists carry no load during the set, and the hands only touch the bar to unhook and rehook it.
- Q: How much weight can I use?
Usually more than on a free bar, since you no longer have to balance it, but the limit tends to be how well the bar sits on your shoulders and how long your arms stay up rather than your legs. When your legs need more load than that, switch to the Smith Machine Front Squat, where your hands hold the bar in place.




