Barbell Block Snatch

Barbell Block Snatch

What Is the Barbell Block Snatch?

Barbell Block Snatch is a compound exercise that primarily targets the shoulders, back, glutes, quads and hamstrings, and also engages the calves, triceps and adductors. It is an advanced-level movement in which the bar starts at rest on a pair of blocks, is pulled explosively off them and is received at arm's length in a full overhead squat before the lifter stands up.

The block start is what makes this variation useful. Because the bar begins from a dead stop above the floor, there is no stretch from lowering into position and only a short distance to accelerate it, so the lifter has to finish the pull aggressively and turn the bar over quickly. Skipping the pull from the floor also takes some of the load off the back and legs, which lets a lifter practice heavy snatches on lighter days or while managing fatigue, and lets someone who struggles off the floor keep training the full lift heavy while that problem is fixed.

In weightlifting programs it is used either as a secondary snatch variation at moderate loads or as a primary snatch exercise on heavy days, usually for low reps early in the session while the lifter is fresh. Block height changes the emphasis: higher blocks stress the finish and aggression of the pull, while lower blocks give more practice at moving the bar past the knees in a good posture. The version shown starts with the bar just below the knees.

The catch is what separates it from the Barbell Block Power Snatch, which is received above parallel and asks less of overhead squat mobility. The Barbell Hang Snatch (Below the Knee) reaches a similar start height, but the lifter lowers the bar there from standing instead of lifting it off blocks. Both are close relatives of the competition Barbell Snatch from the floor, and lifting much more from blocks than from the floor can point to a weakness in the pull off the floor.

The lift suits weightlifters and experienced CrossFit or strength athletes who can already snatch with sound technique. Before loading it, build a stable Barbell Overhead Squat, a confident Barbell Snatch Balance and a strong Barbell Snatch Pull, and learn the full movement with lighter Barbell Hang Snatch work.

Muscles Worked

MuscleActivation
Deltoid
Primary

Instructions

  1. Set two stable blocks of equal height so the loaded barbell rests on them just below your knees, with the bumper plates sitting squarely on top.
  2. Stand with your feet about hip-width apart, toes turned slightly out, and the bar over the middle of your feet.
  3. Take a wide overhand snatch grip, wide enough that the bar would sit in the crease of your hips if you stood up with straight arms.
  4. Bend at the hips and knees to reach the bar, with your back flat, chest up, shoulders slightly in front of the bar, arms straight and weight balanced over the whole foot.
  5. Brace your trunk and push the floor away with your legs to lift the bar off the blocks smoothly, keeping your arms long and the bar close to your thighs.
  6. As the bar reaches your upper thighs, extend your hips, knees and ankles explosively and shrug, keeping the bar close to your body.
  7. Pull your elbows up and out to move yourself down under the bar, stepping your feet slightly wider into your squat stance.
  8. Punch your arms straight and catch the bar overhead in a full squat, with the elbows locked, the bar over the middle of your feet and your torso upright.
  9. Stand up out of the squat with the bar locked overhead and hold it still for a moment.
  10. Lower the bar under control to your hips and then back onto the blocks, and come to a full stop before starting the next rep.

Common Mistakes

  • Jerking the bar off the blocks

    Yanking the bar up before the back is set and the weight is balanced over the whole foot breaks position at the start and throws off the rest of the pull.

  • Pulling early with the arms

    Bending the elbows before the legs and hips have finished driving slows the bar and cuts the extension short.

  • Throwing the hips at the bar

    Snapping the hips forward into the bar sends it looping away from the body and pulls the lifter forward in the catch.

  • Cutting the extension short

    Dropping under the bar before the hips and knees fully extend robs the lift of the drive the block start is meant to train.

  • Pressing out the catch

    Receiving the bar on bent arms and pushing it to lockout strains the elbows and shoulders and counts as a missed lift in competition.

  • Bouncing the bar between reps

    Touching the bar to the blocks and pulling straight away uses rebound instead of a true dead stop, which removes the point of the start.

Injuries

Barbell Block Snatch is a medium risk exercise when performed with proper technique. The deep overhead catch loads the shoulders, wrists, low back and knees at the end of their range, and a bar that drifts too far forward or behind is hard to save. A systematic review of injuries in weightlifters and powerlifters found the spine, shoulder and knee were the most common injury sites in competitive weightlifting, at 2.4 to 3.3 injuries per 1,000 hours of training, a rate similar to other non-contact strength and power sports.

Use solid blocks of equal height with the bumper plates sitting squarely on top, and keep the platform clear of loose plates and gear. Warm up the overhead squat position with a PVC pipe and an empty bar before loading, and keep the back flat and the bar close as it leaves the blocks. If a lift is missed, push the bar away and move out from under it, letting it fall to the platform instead of chasing it, and lower completed reps back to the blocks under control.

To regress, switch to the Barbell Block Power Snatch, which avoids the deep catch, or build the receiving position with the Barbell Overhead Squat and Barbell Snatch Balance. To progress, lower the blocks step by step until the lift becomes the full Barbell Snatch from the floor.

Stop the set if you feel sharp pain or pinching in the shoulder, wrist, elbow or low back, if the overhead position starts to collapse, or if misses become more frequent as you tire.

Frequently Asked Questions

Q: What height should the blocks be for a block snatch?

Knee height is the most common setting, but the bar can start at any height that addresses a lifter's weak point. Higher blocks emphasize an aggressive finish, while lower blocks give more practice at moving the bar past the knees in a good posture.

Q: How is a block snatch different from a hang snatch?

A block snatch starts from a dead stop with the bar resting on blocks, so there is no stretch to help the pull. In a Barbell Hang Snatch (Below the Knee) the lifter lowers the bar from standing to the start position, which usually adds some elastic help from the lowering.

Q: What is the difference between a block snatch and a block power snatch?

Only the catch differs. This lift is received in a full overhead squat, while the Barbell Block Power Snatch is caught above parallel, so it needs a higher pull and less overhead squat mobility.

Q: Is it a problem if I snatch more from blocks than from the floor?

Not necessarily, since the shorter pull and fresher back make heavier block lifts common. A large gap, though, can point to a weakness in the pull from the floor that is worth training directly with pulls and lower start heights.

Q: How heavy should block snatches be and for how many reps?

They are usually done for 1 to 3 reps per set, anywhere from about 70% of your best snatch on lighter days up to maximal weights on heavy days. Each rep should start from a full stop on the blocks.

Turn any exercise into a full workout.

Free for up to 5 clients, with 30 days of Pro to start. No credit card required.