Dumbbell Chest-Supported Front Raise

What Is the Dumbbell Chest-Supported Front Raise?
Dumbbell Chest-Supported Front Raise is an isolation exercise that primarily targets the shoulders, specifically the front deltoids, and also engages the upper chest and the muscles that rotate the shoulder blades upward. It is a beginner-level movement performed kneeling on an incline bench with the chest against the pad, raising a single dumbbell held upright in both hands from a dead hang until the arms point straight ahead.
The pad is what sets this version apart. With the torso resting on the bench, there is no way to lean back, rock the hips or swing the weight up, so the front delts have to do the lifting. The forward lean also changes where the exercise is hardest. At the start the arms hang straight down and the dumbbell puts almost no turning force on the shoulder, and the load builds steadily until the arms are level with the floor at the top. Because the torso is tilted forward, that top position sits well above shoulder height relative to the body, so this version loads the upper part of the raise that a standing Dumbbell Front Raise barely challenges.
The front deltoid does most of the work, with the upper fibers of the chest assisting. An EMG study of competitive bodybuilders found that a seated dumbbell front raise to shoulder height activated the front deltoid and the upper chest more than any of the lateral raise variations it was compared with. As the arms climb past shoulder height relative to the trunk, the serratus anterior and the trapezius also have to rotate the shoulder blades upward, so they contribute more here than in a raise that stops at shoulder height. Holding one dumbbell in both hands keeps the arms moving together, much like the Weight Plate Front Raise, puts the hands in a thumbs-up position, and means only one weight to pick up and set down from the bench.
Presses such as the bench press and overhead press already train the front delts hard, so this raise is an optional accessory rather than a staple. It suits lifters who want strict front delt work without momentum, anyone whose standing front raises turn into a swing, and those who want to strengthen the arms in a high, nearly overhead position with a light load. It usually sits after the main pressing work, with a light dumbbell and moderate to high reps. If the top position feels cramped or the setup is awkward, start with the Dumbbell Seated Front Raise to shoulder height and build up from there.
Muscles Worked
- Deltoid
- Primary
- Pectoralis Major
- Medium
- Serratus Anterior
- Medium
- Upper Trapezius
- Medium
Instructions
- Set an adjustable bench to an incline of about 45 degrees and place a dumbbell on the floor beside the top of the bench.
- Kneel with one knee on the seat, plant the other foot on the floor beside the bench, and lean forward so your chest and stomach rest on the pad with your shoulders just past its top edge.
- Pick up the dumbbell and hold it upright in both hands, wrapping one hand over the other around the handle just under the top plates.
- Let your arms hang straight down in front of the bench, with your elbows straight or slightly soft and your neck in line with your spine.
- Keep your shoulders relaxed away from your ears and your chest pressed into the pad.
- Breathe out and raise the dumbbell forward and up in an arc, keeping your arms straight, until your arms are about level with the floor and the dumbbell is in front of your head.
- Pause briefly at the top without shrugging or lifting your chest off the pad.
- Lower the dumbbell slowly along the same arc until your arms hang straight down again.
- Repeat for the planned reps, then set the dumbbell down beside the bench before stepping off.
Common Mistakes
Lifting the chest off the pad
Raising the chest or arching the back to help the dumbbell up throws away the support that makes this version strict and turns it into a swing.
Shrugging toward the ears
Letting the shoulders ride up shifts work to the upper traps and crowds the front of the shoulder at the top of the lift.
Bending the elbows
Bending the arms as the dumbbell rises shortens the lever and takes load off the front delts, so keep the elbows straight or only slightly soft.
Using too much weight
This version needs a much lighter dumbbell than a standing front raise, and a load you cannot raise until your arms are level with the floor is too heavy.
Dropping the dumbbell back down
Letting the weight fall to the hang skips the lowering phase and jerks the shoulder at the bottom of each rep.
Holding the dumbbell loosely
A single upright dumbbell can slide through a loose grip, so wrap both hands firmly around the handle just under the top plates.
Injuries
Dumbbell Chest-Supported Front Raise is a low risk exercise when performed with proper technique. The load is light and the pad supports the torso, so the lower back stays out of the lift. The part of the body under the most stress is the front and top of the shoulder, where the deltoid, the rotator cuff tendons and the long head of the biceps tendon all work hardest as the arms reach the top of the lift, which in this position is already above shoulder height relative to the torso.
Keep the dumbbell light enough to raise with straight arms and without lifting the chest off the pad, and keep the shoulders down away from the ears so the top of the shoulder is not crowded. Wrap both hands firmly around the handle just under the top plates, since a single upright dumbbell held loosely can slip out of the hands, and set it down beside the bench before getting off. If pressure from the pad makes breathing uncomfortable, adjust your position so your chest and stomach share the contact rather than your sternum alone.
If the top of the lift pinches, stop the raise a little lower, or switch to the Dumbbell Seated Front Raise or the Cable Front Raise, which both finish at shoulder height. To progress, slow the lowering phase or pause for a second at the top before adding weight. Stop the set if you feel sharp or pinching pain at the front or top of the shoulder, pain that lingers after training, or numbness or tingling down the arm, and have a persistent problem checked by a physical therapist or physician.
Other Names for the Dumbbell Chest-Supported Front Raise
The Dumbbell Chest-Supported Front Raise is also known as:
- Prone Incline Dumbbell Front Raise
Frequently Asked Questions
- Q: Why do a front raise with chest support instead of standing?
The pad stops you from leaning back or swinging, so the front delts have to lift the weight on every rep. The forward lean also makes the top of the lift the hardest part, while a standing Dumbbell Front Raise is hardest at shoulder height and gets easier above it.
- Q: Why hold one dumbbell with both hands?
One dumbbell keeps both arms moving together in a thumbs-up position and is easy to pick up and set down while you are kneeling on the bench. If you want each arm to work on its own, use two dumbbells in the same setup.
- Q: What bench angle should I use?
An incline of about 45 degrees works well and matches the usual setup. A lower incline puts the top of the lift further overhead relative to your torso, while a steeper one makes the exercise feel more like a standing front raise.
- Q: How high should I raise the dumbbell?
Raise it until your arms are about level with the floor and the dumbbell is in front of your head. If that top position pinches the front of your shoulder, stop a little lower.
- Q: Do I need front raises if I already press?
Not necessarily. Bench presses, overhead presses and push-ups already train the front delts hard, so this raise is an optional extra for lifters who want more direct front delt work.




