EZ Bar Incline Front Raise

What Is the EZ Bar Incline Front Raise?
EZ Bar Incline Front Raise is an isolation exercise that primarily targets the shoulders, especially the front deltoid, and also engages the upper chest and the muscles that rotate the shoulder blades upward. It is a beginner-level movement performed seated with the back and head resting on an incline bench, raising an EZ bar from the thighs in a wide arc until the arms point up over the face.
The bench is what sets this variation apart. With the back pinned to the pad there is no way to rock the torso or swing the bar, so the front deltoids have to start every rep on their own. Leaning back also changes where the lift is hardest. The bar is heaviest when the arms are parallel to the floor, and on an incline that happens early, just after the bar leaves the thighs. As the bar travels up over the face the load fades, so the top of the rep is a brief pause rather than the hardest point, the opposite of a Barbell Front Raise done standing.
As a movement pattern, the front raise is a front deltoid and upper chest exercise rather than a shoulder widener. In an EMG study of competitive bodybuilders, a seated dumbbell front raise activated the front deltoid and the clavicular head of the pectoralis major more than any of the lateral raise variations tested. Because the incline version carries the bar well above shoulder height, the serratus anterior and trapezius also work to rotate the shoulder blades as the arms climb. The angled grip of the EZ bar turns the palms slightly inward compared with a straight bar, which many lifters find easier on the wrists.
The front deltoids already do a lot of work in bench, incline and overhead pressing, so most programs need only a few sets of direct front raises, usually placed after the presses with light to moderate loads for higher reps. This exercise suits lifters who want strict, swing-free front deltoid work, bodybuilders bringing up lagging front delts, and beginners learning to raise a bar without using the back. Anyone who cannot yet raise the arms overhead without discomfort can start with a Dumbbell Seated Front Raise taken to shoulder height. For the face-down version of the same idea, see the Dumbbell Chest-Supported Front Raise.
Muscles Worked
- Deltoid
- Primary
- Pectoralis Major
- High
- Serratus Anterior
- Medium
- Upper Trapezius
- Medium
Instructions
- Set an adjustable bench to an incline of about 45 to 60 degrees and sit with your back and head against the pad and your feet flat on the floor.
- Hold an EZ bar with an overhand grip on the angled sections, hands about shoulder-width apart, and rest it on your thighs.
- Pull your shoulders down away from your ears and keep a soft bend in your elbows.
- Exhale and raise the bar in a wide arc up and away from your body, keeping your back on the pad and your elbow angle fixed.
- Continue until your arms point about straight up, with the bar over your face. Do not let it drift behind your head.
- Pause briefly, then inhale and lower the bar along the same arc under control, taking about 2 to 3 seconds.
- Stop just above your thighs or touch them lightly without bouncing, then start the next rep.
Common Mistakes
Lifting the back off the pad
Leaning forward off the bench to get the bar moving brings back the momentum the incline is meant to remove.
Bending the elbows as the bar rises
Turning the raise into a curl or a press shortens the lever and takes the work off the front deltoids.
Taking the bar past vertical
Letting the bar drift behind the head stretches the front of the shoulder without adding any work for the deltoids.
Shrugging toward the ears
Hiking the shoulders shifts the effort into the upper traps and crowds the top of the shoulder joint.
Bouncing off the thighs
Dropping the bar onto the legs and rebounding skips the first part of the lift, which is the hardest part on an incline.
Using too much weight
A bar heavy enough to need a rock off the pad or a bend in the elbows is too heavy for this isolation movement.
Injuries
EZ Bar Incline Front Raise is a low risk exercise when performed with proper technique. The bench supports the back and the loads are light, so the lower back is not at risk. The part that takes the strain is the front and top of the shoulder, where the tendons of the rotator cuff and the long head of the biceps pass. A palms-down grip turns the upper arm inward, and raising it high in that position can pinch these tendons in some lifters.
Keep the load light enough that the bar moves without rocking off the pad or bending the elbows further, and stop each rep when the arms point straight up over the face. Letting the bar drift behind the head adds stretch to the front of the shoulder without adding any work for the deltoids. Lower the bar under control instead of dropping it onto the thighs, and keep the shoulders pulled down away from the ears.
If raising the arms overhead is uncomfortable, regress to a Dumbbell Seated Front Raise or a Cable Front Raise taken only to shoulder height, where the palms can also face each other. To progress, add load in small steps, slow the lowering phase, or pause briefly with the arms parallel to the floor. Stop the set if you feel a sharp or pinching pain at the front or top of the shoulder, a painful click, or numbness or tingling down the arm.
Frequently Asked Questions
- Q: How is this different from a standing front raise?
The bench stops you from swinging the bar, and leaning back moves the hardest point to just after the bar leaves the thighs instead of at shoulder height. The bar also travels higher, finishing over the face, where the load is light. The standing Barbell Front Raise is hardest at the top of its range instead.
- Q: How is it different from a chest-supported front raise?
In the Dumbbell Chest-Supported Front Raise you lie face down on the incline, so the weights are hardest to hold high in the range. Lying back on the bench, as here, puts the hardest part near the bottom, so the two make a good pair across a training week.
- Q: How high should the bar go?
Raise it until your arms point about straight up over your face, then lower it. Going further adds no work for the deltoids, and if the top of the range pinches your shoulder, stop at eye level instead.
- Q: What bench angle should I use?
An incline of about 45 to 60 degrees works for most people. A more upright bench makes the lift feel closer to a standing front raise, while a lower one makes the first part of the lift harder and the top easier.
- Q: Do I need front raises if I already bench and overhead press?
Not necessarily, because pressing already trains the front deltoids hard. A few sets are worth adding if your front delts lag or you want strict isolation work, but heavy pressing such as the EZ Bar Overhead Press should stay the base.
- Q: Why use an EZ bar instead of a straight bar?
The angled grip lets your palms turn slightly inward, which many lifters find easier on the wrists and the front of the shoulder than a fully palms-down straight bar. A straight bar or a pair of dumbbells works the same muscles if that is what you have.




